2 thoughts on “Make Land To House Logo

  1. I have made a ram pump per your instructions and it worked fine for a while. Now I rap the check valve sharply to get the valve to close. Then it will pump for a short while then stops . My thoughts were air in line but purged with hose and am reasonably sure it is air free. I have a 30 inch head and her at spurt of three inches out of valve . I have the inverted tee on the inlet and am not bothered with leaves. Any suggestion would be helpful. I enjoy your videos Don

    1. Air in the drive pipe is often the cause of your issue. But you could also have a leak in the delivery pipe or a very small leak in the pressure tank. If you have the delivery height too low you might be losing pressure from the pressure tank. How high are you pumping water too?

Leave a Reply to Seth Johnson Cancel reply

Your email address will not be published. Required fields are marked *